Notifications
Clear all
Topic starter
22/05/2021 7:54 am
Hi guys,
when using the ajh vco with the eloquencer and I am on C0 it is still not the lowest note it could get. Is there a possibility to tweak the output or calibrate so that I can say for example cv 1 is lower then cv2?
24/05/2021 9:23 am
Hi @tosh,
When you set a C0 in the Eloquencer interface, you will have 0 Volts at the output. We assume that oscillators can reach its lowest value receiving 0 Volts at its input if they have an uni-polar input. If the oscillator input is bipolar things are different, does your oscillator have any offset? Do you have the possibility to apply a -5V offset to the Eloquencer CV output using an utility module? Make sure this offset keeps the linearity